Show Abstract ▼

Abstract: New mineralogical studies of Lafayette reveal that it contains a notably variable abundance of martian carbonate. Four percent was identified in mesostasis (3.2%) and olivine-hosted (0.8%) fractures in one polished section, but only 0.2% of both textural types in another. The Lafayette carbonates are Mg0.0-2.0Cc13.2-38.6Sd17.7-81.9Rh3.1-42.9. They have undergone variable but extensive amounts of dissolution and replacement as the nakhlite secondary fluid evolved, associated with the precipitation of ferric saponite in olivine fractures and a serpentine-like phyllosilicate in the mesostasis. The mesostasis carbonate has undergone the highest degree of corrosion and replacement. TEM analysis has shown the presence of Fe-(hydr)oxide (likely ferrihydrite) nanoparticles on olivine-hosted carbonates which can be linked to the cessation of more extensive carbonate dissolution at those sites. The mesostasis serpentine-like mineral has been described here on the basis of WDS and EDX analyses, HRTEM and Fe-K XANES, as odinite, a ferric, 0.7 nm d001-spacings phyllosilicate mineral with a characteristic 1:1 serpentine-like structure. The carbonate dissolution stage and then formation of Fe-(hydr)oxide nanoparticles occurred under circumneutral-alkaline conditions 7 < pH < 10. This range of pH is also where the general dissolution mechanism switched from a proton-promoted, to a water hydrolysis reaction associated with a reduction in the dissolution rates. As dissolution rates were reduced and the fluid had cooled to ≤50°C, the precipitation of the ferric saponite and odinite, a phyllosilicate associated with temperatures of ∼25°C, dominated over the carbonate dissolution. The extensive dissolution of such crustal carbonate across the upper martian crust, producing bicarbonate and carbon dioxide, and the coupled formation of ferric phyllosilicates, would lead to the formation of CH4 in substantial amounts via a Fischer-Tropsch type reaction. The results of our study illustrate a process to explain the relatively low abundance of detected carbonate on Mars and a likely source for some of the methane on Mars.

Show Abstract ▼

Abstract: Introduction: Airless planetary bodies with surfaces exposed to the space environment are bombarded by electrons and protons from the solar wind and cosmic rays, as well as micrometeorites, resulting in space weathering [1]. Features of space weathering include partially amorphised grain surface rims, measuring up to ~100 nm thick, containing nanophase Fe metal (npFe0) particles, vesicular blistering, and solar flare tracks [1,2]. Space weathered samples collected by the JAXA Hayabusa spacecraft from asteroid Itokawa have previously been analysed using the I14 X-ray nanoprobe beamline at Diamond Light Source synchrotron, measuring Fe-K X-ray absorption near-edge spectroscopy (XANES), and revealing an increased ferric-ferrous ratio (Fe3+/ΣFe) relative to their respective host grain mineralogy [3]. In this study, we seek to better understand the formation of space weathered lunar surface soil samples collected during the Apollo 17 mission, investigating the Fe-redox variations observed in the dominant silicate phase and the nano-grains of the space weathered rims using Fe-K XANES and EELS, with high-resolution STEM imaging. Methods/Materials: The lunar sample number is 78481,29 - a surface sample collected from the top 1 cm of trench soils at Station 8 of Apollo 17 [4]. Three FIB lift-out sections have been extracted successfully from lunar grains identified to have space weathered surfaces. Two of the lunar grains were augite pyroxene, En81Fs16 and En85Fs12, and one olivine, Fa39. Using the I14 X-ray Nanoprobe Beamline at Diamond, Fe-Kα XAS spectra are obtained from a series of XRF maps over the samples, with energies typically in the range 7000-7300 eV, with a higher energy resolution range over the XANES features (~7100-7150 eV). The XANES maps are processed using Mantis 2.3.02 [5], and isolated spectra normalized in Athena 0.8.056 [6]. By observing increasing shifts in the 1s→3d transition pre- absorption-edge peak centroid energy positions, the Fe-redox variations can be estimated between the sample host mineralogy and the space weathered zone, when compared to reference minerals of known ferric-ferrous ratio (Fe3+/ΣFe). A JEOL ARM200CF and JEOL JEM-ARM300CF instrument was used for EELS analyses and high-resolution STEM imaging respectively, at ePSIC in Diamond. EELS are performed using an accelerating voltage of 200 keV, current 15 μA, and 0.25eV/ch with a 5 mm EELS aperture, measuring linescans from the host to the space weathered zones to provide verification of the Fe-redox variation by observing the shifts in the Fe-Lα peaks. Results: HR-STEM imaging confirmed the expected partial amorphisation and npFe0 particles (Fe0 metal confirmed observing lattice fringe spacings of ~2.06 Å) in the space weathered zones of all three lunar samples. XANES mapping was able to identify the space weathered zone separate from the host grain mineralogy, and analyses of the XANES spectra from each revealed a consistent positive shift in the 1s→3d pre-edge centroid energy positions for the space weathered zone when compared to the host. Increases of up to ~0.23 eV in the space weathered (SW) zone, compared to the substrate host mineralogy of augite or olivine, suggests an increase in ferric content in the space weathered zones up to ΔFe3+/ΣFe ~0.14 ±0.03. Positive shifts in the absorption edge positions for SW zones also support these results. A total of 18 EELS linescans measured, at various locations along the space weathered rims in all three lunar samples, also shows a consistent increased shift in the Fe-L peak energy position. A positive shift in the EELS Fe-L peak position is indicative of increased ferric content, as shown by reference minerals measured including Fe-rich olivine (Fe3+/ΣFe = 0.00) and magnetite (Fe3+/ΣFe = 0.67) with average EELS Fe-L peak positions of ~712.1 eV and ~713.6 eV respectively.

Open Access

Show Abstract ▼

Abstract: Space weathering due to the bombardment of electrons and solar wind upon the exposed lunar surface shows as an apparent spectral darkening and reddening in ground-based and lunar-orbital observations. Space weathered rims have been observed on soil surface samples, returned by the Apollo landings, featuring amorphized material and nanophase Fe metal (npFe⁰) particles formed due to the implantation of solar wind H⁺ ions reducing the host grain mineral oxides to form metal. Oxidation of these Fe particles has also been shown, and a suggested correlation between oxidation and lunar soil maturity.In this study, we investigate Fe-redox changes in the space weathered rims of Apollo 17 lunar surface soil samples, using TEM and X-ray nanoprobe Fe-K XANES.

Show Abstract ▼

Abstract: Martian meteorite Northwest Africa (NWA) 8114 – a paired stone to NWA 7034 – provides an opportunity to examine the thermal history of a martian regolith and study near-surface processes and ancient environmental conditions near an impact crater on Mars. Our study reports petrographic and alteration textures and focuses on pyroxene and iron oxide grains. Some of the pyroxene clasts show exsolution lamellae, indicating a high temperature magmatic origin and slow cooling. However, transmission electron microscopy reveals that other predominantly pyroxene clasts are porous and have partially re-crystallised to form magnetite and a K-bearing feldspathic glassy material, together with relict pyroxene. This breakdown event was associated with oxidation, with up to 25% Fe3+/ΣFe in the relict pyroxene measured using Fe-K XANES. By comparison with previous studies, this breakdown and oxidation of pyroxene is most likely to be a result of impact shock heating, being held at a temperature above 700 °C for at least 7 days in an oxidising regolith environment. We report an approximate 40Ar-39Ar maximum age of 1.13 Ga to 1.25 Ga for an individual, separated, augite clast. The disturbed nature of the spectra precludes precise age determination. In section, this clast is porous and contains iron oxide grains. This shows that it has undergone the high temperature partial breakdown seen in other relict pyroxene clasts, and has up to 25% Fe3+/ΣFe. We infer that the age corresponds to the impact shock heating event that led to the high temperature breakdown of many of the pyroxenes, after consolidation of the impact ejecta blanket. High temperatures, above 700 °C, may have been maintained for long enough to remobilise and congruently partially melt some of the alkali feldspar clasts to produce the feldspar veins and aureoles that crosscut, and in some cases surround, the oxidised pyroxene. However, the veins could alternatively be the result of a hydrothermal event in the impact regolith. A simple Fourier cooling model suggests that a regolith of at least five metres depth would be sufficient to maintain temperatures associated with the pyroxene breakdown for over seven days. Low temperature hydrous alteration took place forming goethite, identified via XRD, XANES and FTIR. Comparing with previous studies, the goethite is likely to be terrestrial alteration pseudomorphing martian pyrite.