I07-Surface & interface diffraction
|
Diamond Proposal Number(s):
[13089]
Abstract: Single crystal [0 0 1], [1 1 0], and [1 1 1]-oriented UO2 thin films were utilised to investigate the orientational dependence of radiolytic dissolution. The films were exposed to water in the presence of a synchrotron x-ray source to induce dissolution, with X-ray Reflectivity (XRR) used to observe changes in morphology as a function of exposure time. The [0 0 1] and [1 1 0]-oriented films were found to corrode at comparable rates, however, the [1 1 1] film was significantly more corrosion resistant, passivating after the initial 90 s dissolution period. This result shows the orientational dependence of UO2 dissolution, which may have important consequences for theoretical dissolution models.
|
Sep 2018
|
|
B18-Core EXAFS
I15-Extreme Conditions
I22-Small angle scattering & Diffraction
|
Diamond Proposal Number(s):
[12704, 13559, 15276, 15966]
Abstract: Uranium is typically the most abundant radionuclide by mass in radioactive wastes and is a significant component of effluent streams at nuclear facilities. Actinide (IV) (An(IV)) colloids formed via various pathways, including corrosion of spent nuclear fuel, have the potential to greatly enhance the mobility of poorly soluble An(IV) forms, including uranium. This is particularly important in conditions relevant to decommissioning of nuclear facilities and the geological disposal of radioactive waste. Previous studies have suggested that silicate could stabilise U(IV) colloids. Here the formation, composition and structure of U(IV)-silicate colloids under the alkaline conditions relevant to spent nuclear fuel storage and disposal were investigated using a range of state of the art techniques. The colloids are formed across a range of pH conditions (9-10.5) and silicate concentrations (2-4 mM) and have a primary particle size 1-10 nm, also forming suspended aggregates < 220 nm. X-ray absorption spectroscopy, ultrafiltration and scanning transmission electron microscopy confirm the particles are U(IV)-silicates. Additional evidence from X-ray diffraction and pair distribution function data suggests the primary particles are composed of a UO2-rich core and a U-silicate shell. U(IV)-silicate colloids formation correlates with the formation of U(OH)3(H3SiO4)32- complexes in solution indicating they are likely particle precursors. Finally, these colloids form under a range of condition relevant to nuclear fuel storage and geological disposal of radioactive waste and represent a potential pathway for U mobility in these systems.
|
Jul 2018
|
|
B18-Core EXAFS
|
Diamond Proposal Number(s):
[13037, 13580]
Open Access
Abstract: Cobalt is a waste product in many industrial processes and its most common radioactive isotope – 60Co – is a by-product of nuclear reactors. To better understand the mobility and fate of Co in natural and contaminated environments we investigated Co sorption behaviour to the common soil and sediment constituents ferrihydrite, kaolinite, humic acid (HA), and ferrihydrite-HA and kaolinite-HA organo-mineral composites using sorption batch experiments, synchrotron X-ray absorption spectroscopy (EXAFS), and scanning transmission electron microscopy (STEM). We measured the sorption of Co to the end-member mineral and organic phases and the composites as a function of pH, ionic strength and Co concentration, and also for the composites as a function of organic carbon concentration, with composites made containing a wide range of organic carbon contents. We then determined the molecular mechanisms of Co sorption to the end-member phases and the composites, and used this information to develop molecularly constrained thermodynamic surface complexation models to quantify Co sorption. Sorption to the ferrihydrite-HA and kaolinite-HA organo-mineral composites was found to be intermediate to both of the end-member phases, displaying enhanced sorption respective to the mineral end-member phase at mid-low pH. EXAFS analysis shows that there is a universal sorption mechanism accounting for Co sorption to the end-member mineral and organic phases and the organo-mineral composites at mid-high pH, in which Co sorbs to these phases via inner-sphere bidentate binuclear surface complexes. At mid-low pH, sorption to all the phases except ferrihydrite is the result of outer-sphere complexation. Our new molecularly constrained thermodynamic surface complexation models for Co sorption to ferrihydrite, kaolinite, HA, and ferrihydrite-HA and kaolinite-HA organo-mineral composites, show that Co sorption to the composites cannot be modelled assuming linear additivity of Co sorption to the end-member phases.
|
Jul 2018
|
|
|
Open Access
Abstract: A thorough understanding of the chemistry of PuO2 is critical to the design of next-generation nuclear fuels and the long-term storage of nuclear materials. Despite over 75 years of study, the ground-state magnetic structure of PuO2 remains a matter of much debate. Experimental studies loosely indicate a diamagnetic (DM) ground-state, whereas theoretical methods have proposed either a collinear ferromagnetic (FM) or anti-ferromagnetic (AFM) ground-state, both of which would be expected to cause a distortion from the reported Fm[3 with combining macron]m symmetry. In this work, we have used accurate calculations based on the density functional theory (DFT) to systematically investigate the magnetic structure of PuO2 to resolve this controversy. We have explicitly considered electron-correlation, spin–orbit interaction and noncollinear magnetic contributions to identify a hereto unknown longitudinal 3k AFM ground-state that retains Fm[3 with combining macron]m crystal symmetry. Given the broad interest in plutonium materials and the inherent experimental difficulties of handling this compound, the results presented in this paper have considerable implications for future computational studies relating to PuO2 and related actinide structures. As the crystal structure is coupled by spin–orbit interactions to the magnetic state, it is imperative to consider relativity when creating computational models.
|
Jul 2018
|
|
B18-Core EXAFS
|
Diamond Proposal Number(s):
[9621]
Open Access
Abstract: Np(V) behaviour in alkaline, calcite containing systems was studied over a range of neptunium concentrations (1.62 × 10−3 μM–1.62 μM) in two synthetic, high pH, cement leachates under a CO2 controlled atmosphere. The cement leachates were representative of conditions expected in an older (pH 10.5, Ca2+) and younger (pH 13.3, Na+, K+, Ca2+) cementitious geological disposal facility. These systems were studied using a combination of batch sorption and solubility experiments, X-ray absorption spectroscopy, and geochemical modelling to describe Np behaviour. Np(V) solubility in calcite equilibrated old and young cement leachates (OCL and YCL) was 9.7 and 0.084 μM, respectively. In the OCL system, this was consistent with a Np(V)O2OH(am) phase controlling solubility. However, this phase did not explain the very low Np(V) solubility observed in the YCL system. This inconsistency was explored further with a range of pH 13.3 solubility experiments with and variable Ca2+(aq) concentrations. These experiments showed that at pH 13.3, Np(V) solubility decreased with increasing Ca2+ concentration confirming that Ca2+ was a critical control on Np solubility in the YCL systems. X-ray absorption near-edge structure spectroscopy on the precipitate from the 42.2 μM Np(V) experiment confirmed that a Np(V) dioxygenyl species was dominant. This was supported by both geochemical and extended X-ray absorption fine structure data, which suggested a calcium containing Np(V) hydroxide phase was controlling solubility. In YCL systems, sorption of Np(V) to calcite was observed across a range of Np concentrations and solid to solution ratios. A combination of both surface complexation and/or precipitation was likely responsible for the observed Np(V) reaction with calcite in these systems. In the OCL sorption experiments, Np(V) sorption to calcite across a range of Np concentrations was dependent on the solid to solution ratio which is consistent with the formation of a mono-nuclear surface complex. All systems demonstrated slow sorption kinetics, with reaction times of weeks needed to reach apparent equilibrium. This could be explained by slow recrystallisation of the calcite surface and/or the presence of Np(V) colloidal species. Overall, these data provide valuable new insights into Np(V) and actinide(V) behaviour in alkaline conditions of relevance to the disposal of intermediate level radioactive wastes.
|
Jun 2018
|
|
I12-JEEP: Joint Engineering, Environmental and Processing
|
Diamond Proposal Number(s):
[8336, 9127]
Open Access
Abstract: To reflect potential conditions in a geological disposal facility, uranium was encapsulated in grout and submersed in de-ionised water for time periods between 2–47 weeks. Synchrotron X-ray Powder Diffraction and X-ray Tomography were used to identify the dominant corrosion products and measure their dimensions. Uranium dioxide was observed as the dominant corrosion product and time dependent thickness measurements were used to calculate oxidation rates. The effectiveness of physical and chemical grout properties to uranium corrosion and mobilisation is discussed and Inductively Coupled Plasma Mass Spectrometry was used to measure 238U(aq) content in the residual water of several samples.
|
Jun 2018
|
|
B18-Core EXAFS
|
Diamond Proposal Number(s):
[7367, 7593, 8070]
Open Access
Abstract: Radiotoxic uranium contamination in natural systems and nuclear waste containment can be sequestered by incorporation into naturally abundant iron (oxyhydr)oxides such as hematite (α-Fe2O3) during mineral growth. The stability and properties of the resulting uranium-doped material are impacted by the local coordination environment of incorporated uranium. While measurements of uranium coordination in hematite have been attempted using extended X-ray absorption fine structure (EXAFS) analysis, traditional shell-by-shell EXAFS fitting yields ambiguous results. We used hybrid functional ab initio molecular dynamics (AIMD) simulations for various defect configurations to generate synthetic EXAFS spectra which were combined with adsorbed uranyl spectra to fit experimental U L3-edge EXAFS for U6+-doped hematite. We discovered that the hematite crystal structure accommodates a trans-dioxo uranyl-like configuration for U6+ that substitutes for structural Fe3+, which requires two partially protonated Fe vacancies situated at opposing corner-sharing lattice sites. Surprisingly, the best match to experiment included significant proportions of vacancy configurations other than the minimum-energy configuration, pointing to the importance of incorporation mechanisms and kinetics over thermodynamics in determining the state of an impurity incorporated in a host phase under low temperature hydrothermal conditions.
|
May 2018
|
|
I20-Scanning-X-ray spectroscopy (XAS/XES)
|
Ashley J.
Wooles
,
David P.
Mills
,
Floriana
Tuna
,
Eric J. L.
Mcinnes
,
Gareth T. W.
Law
,
Adam J.
Fuller
,
Felipe
Kremer
,
Mark
Ridgway
,
William
Lewis
,
Laura
Gagliardi
,
Bess
Vlaisavljevich
,
Stephen T.
Liddle
Diamond Proposal Number(s):
[9621, 13559]
Open Access
Abstract: Despite the fact that non-aqueous uranium chemistry is over 60 years old, most polarised-covalent uranium-element multiple bonds involve formal uranium oxidation states IV, V, and VI. The paucity of uranium(III) congeners is because, in common with metal-ligand multiple bonding generally, such linkages involve strongly donating, charge-loaded ligands that bind best to electron-poor metals and inherently promote disproportionation of uranium(III). Here, we report the synthesis of hexauranium-methanediide nanometre-scale rings. Combined experimental and computational studies suggest overall the presence of formal uranium(III) and (IV) ions, though electron delocalisation in this Kramers system cannot be definitively ruled out, and the resulting polarised-covalent U = C bonds are supported by iodide and δ-bonded arene bridges. The arenes provide reservoirs that accommodate charge, thus avoiding inter-electronic repulsion that would destabilise these low oxidation state metal-ligand multiple bonds. Using arenes as electronic buffers could constitute a general synthetic strategy by which to stabilise otherwise inherently unstable metal-ligand linkages.
|
May 2018
|
|
B18-Core EXAFS
|
Diamond Proposal Number(s):
[17060]
Abstract: Sr-containing calcium carbonates were precipitated from solutions containing Ca(OH)2, SrCl2 and Na2CO3 in a reactor where constant solution composition was maintained. The total concentration of divalent ions was same in all experiments, but the Sr/Ca ratio was varied between 0.002 and 0.86, and the pH value was between 12.02 and 12.25. All solutions were oversaturated with respect to calcite (SIcalcite = 1.2-1.5). Calcite was the only product formed at low Sr/Ca ratios, but at Sr/Ca ≥ 0.45 strontianite was detected in some systems. Sr-rich precipitate was observed in both a surface layer on (6.9-6 µm) rhombic calcite seed crystals and as smaller (> 3.64-1.96 µm) calcite crystals that were elongated along their C-axis. The degree of crystal elongation increased with the Sr/Ca ratio in those crystals. Precipitates recovered from low Sr/Ca ratio experiments exhibited an XRD spectrum identical to that of rhombic calcite, however the peaks attributed to Sr-containing calcite shifted progressively to lower 2θ values with increasing solution Sr/Ca ratio, indicating increased lattice volume. Sr K-edge EXAFS analysis of the precipitates showed that the shift in morphology and lattice volume is accompanied by a change in the local coordination of Sr2+ in calcite. The Sr-O bond lengths were similar to the Ca-O bond lengths in calcite, but Sr-O coordination increased from 6 fold in crystals containing 0.21 Wt. % Sr, to 8 fold in crystals containing 9.47 Wt. % Sr, and the Sr-Ca coordination decreased from 6 and 6 (for the first and second Sr-Ca shells respectively) to 4 and 1. It is suggested that Sr2+ undergoes preferential incorporation at obtuse (+) growth sites on the calcite surface due to its large ionic radius (1.13 Å), and this increases the growth rate parallel to the C-axis, resulting in the observed elongation in this direction.
|
Apr 2018
|
|
I18-Microfocus Spectroscopy
|
Diamond Proposal Number(s):
[12505]
Abstract: Stainless steel coupons have been exposed to uranium-containing nitric acid solutions, in conditions similar to those found in various uranium handling nuclear facilities across the nuclear fuel cycle. Solid state analysis of the stainless steel samples and solution composition analysis were undertaken to gain a better understanding of the contamination process mechanisms. Stainless steel coupons were immersed in 12 M HNO3 containing uranium (1 g/L), in the form of uranyl, for periods of up to 255 days. Uranium contamination was observed across all time lengths of exposure. Solution analysis indicated that the levels of contamination reached an equilibrium state after ~14 days. Investigations using Raman microscopy, synchrotron microfocus X-ray fluorescence and X-ray absorption spectroscopy showed inhomogeneous localization of uranyl species within the passive layer of the stainless steel surface. Over longer time lengths of exposure these contaminant species were predominantly found to locate within intergranular regions of the stainless steel. This finding should be taken into consideration when developing decontamination protocols for corroded stainless steel that has been exposed to uranium, to facilitate metal reuse/recycle and minimize hazardous waste volumes.
|
Feb 2018
|
|