Publication

Article Metrics

Citations


Online attention

Dynamic contact strain measurement by time-resolved stroboscopic energy dispersive synchrotron X-ray diffraction

DOI: 10.1111/str.12221 DOI Help

Authors: M. Mostafavi (University of Bristol) , D. M. Collins (University of Oxford) , M. J. Peel (University of Bristol) , C. Reinhard (Diamond Light Source) , S. M. Barhli (University of Oxford) , R. Mills (University of Sheffield) , M. B. Marshall (University of Sheffield) , R. S. Dwyer-joyce (University of Sheffield) , T. Connolley (Diamond Light Source)
Co-authored by industrial partner: No

Type: Journal Paper
Journal: Strain

State: Published (Approved)
Published: January 2017
Diamond Proposal Number(s): 10053

Abstract: Recent developments of synchrotron X-ray sources and dedicated high-energy beamlines are now enabling strain measurements from large volumes of industrially relevant metallic materials. Such capability is allowing the validation of novel and alternative nondestructive experimental methods of strain measurement or computational models of complex deformation processes. This study describes the first dynamic contact strain measurement of a ball bearing using stroboscopic energy dispersive X-ray diffraction. The experiment probed the dynamic contact strain in the outer raceway of a test bearing. The inner raceway of the bearing was attached to a shaft rotating at 150 revolutions per minute, and the outer raceway, where the measurements were made, was fixed in a stationary bearing housing. A triggering system was used to synchronise the data acquisition of the energy dispersive X-ray diffraction detector with the bearing rotation. Specifically, diffraction data were acquired, stroboscopically, from the material volume within the raceway, in a known location, when the ball was positioned directly below it. A total of 20 s of accumulated diffraction signal was recorded, acquiring 2 ms of data per revolution, providing diffraction patterns of sufficient quality for the dynamic contact strain to be measured. Macromechanical stress field was calculated from the micromechanical strains measured from five lattice planes. This allowed a comparison of the experimentally measured stress field and that of finite element simulations. Good agreement was observed between the finite element results and experimental measurements indicating the applicability of this novel dynamic strain measurement technique for tribological systems.

Journal Keywords: contact stress; energy dispersive X-ray diffraction; finite element analysis; stroboscopic measurement; tribology

Subject Areas: Materials, Engineering


Instruments: I12-JEEP: Joint Engineering, Environmental and Processing

Discipline Tags:



Technical Tags: