Design for the diamond longitudinal bunch-by-bunch

DOI: 10.18429/JACoW-IBIC2016-TUPG12

Authors: A. F. D. Morgan (Diamond Light Source) , G. Rehm (Diamond Light Source)
Co-authored by industrial partner: No

Type: Conference Paper
Conference: IBIC2016
Peer Reviewed: No

State: Published (Approved)
Published: September 2016

Abstract: In 2017 it is planned to install some additional normal conducting cavities into the Diamond storage ring. In order to deal with the potential higher order modes in these, we are designing a longitudinal bunch-by-bunch feedback system. This paper will focus on the design of the overloaded cavity kicker, adapted to the Diamond beam pipe cross section. The design has evolved in order to reduce the strong 3rd harmonic resonance seen on the introduction of the racetrack beam pipe. Through a combination of geometry optimisation and the addition of integrated taper transitions this harmonic has been greatly reduced while also minimising sharp resonances below 15 GHz. The major features will be described, as well as the expected performance parameters.

Subject Areas: Engineering


Technical Areas: Mechanical Engineering

Added On: 06/04/2017 14:35

Discipline Tags:

Engineering & Technology

Technical Tags: