Open Access

Open Access

Show Abstract ▼

Abstract: Photoelectron spectroscopy is a powerful characterisation tool for semiconductor surfaces and interfaces, providing in principle a correlation between the electronic band structure and surface chemistry along with quantitative parameters such as the electron affinity, interface potential, band bending and band offsets. However, measurements are often limited to ultrahigh vacuum and only the top few atomic layers are probed. The technique is seldom applied as an in situ probe of surface processing; information is usually provided before and after processing in a separate environment, leading to a reduction in reproducibility. Advances in instrumentation, in particular electron detection has enabled these limitations to be addressed, for example allowing measurement at near-ambient pressures and the in situ, real-time monitoring of surface processing and interface formation. A further limitation is the influence of the measurement method through irreversible chemical effects such as radiation damage during X-ray exposure and reversible physical effects such as the charging of low conductivity materials. For wide-gap semiconductors such as oxides and carbon-based materials, these effects can be compounded and severe. Here we show how real-time and near-ambient pressure photoelectron spectroscopy can be applied to identify and quantify these effects, using a gold alloy, gallium oxide and semiconducting diamond as examples. A small binding energy change due to thermal expansion is followed in real-time for the alloy while the two semiconductors show larger temperature-induced changes in binding energy that, although superficially similar, are identified as having different and multiple origins, related to surface oxygen bonding, surface band-bending and a room-temperature surface photovoltage. The latter affects the p-type diamond at temperatures up to 400 °C when exposed to X-ray, UV and synchrotron radiation and under UHV and 1 mbar of O2. Real-time monitoring and near-ambient pressure measurement with different excitation sources has been used to identify the mechanisms behind the observed changes in spectral parameters that are different for each of the three materials. Corrected binding energy values aid the completion of the energy band diagrams for these wide-gap semiconductors and provide protocols for surface processing to engineer key surface and interface parameters.

Show Abstract ▼

Abstract: In situ photoemission and near-edge X-ray absorption fine structure (NEXAFS) techniques have been used to study the interaction of CO2 with an ionic liquid thin film. A thin film of the superbasic ionic liquid (SBIL) trihexyltetradecylphosphonium benzimidazolide ([P66614][benzim]) was prepared on a rutile TiO2 (110) surface and exposed to CO2 at near-ambient pressures. NEXAFS measurements combined with density functional theory calculations indicate a realignment of [benzim]− anions from 27° from the surface normal to 54° upon exposure to CO2. Angle-resolved X-ray photoelectron spectroscopy (AR-XPS) shows evidence of irreversible CO2 absorption in thin films of [P66614][benzim] and a greater concentration of CO2-reacted anions in the deeper layers. These results give a new perspective on CO2 uptake in ionic liquids and fundamental interactions at the liquid–gas interface. Understanding this interfacial behavior is important for developing ILs for gas capture applications and may influence the performance of other IL-based technologies.

Open Access

Show Abstract ▼

Abstract: Near ambient pressure X-ray photoelectron spectroscopy (NAP-XPS) was used to study the chemical states of a range of alumina-supported monometallic Pd and bimetallic Pd-Pt nanocatalysts, under methane oxidation conditions. It has been suggested before that for optimal complete methane oxidation, palladium needs to be in an oxidised state. These experiments, combining NAP-XPS with a broad range of characterisation techniques, demonstrate a clear link between Pt presence, Pd oxidation, and catalyst activity under stoichiometric reaction conditions. Under oxygen-rich conditions this behaviour is less clear, as all of the palladium tends to be oxidised, but there are still benefits to the addition of Pt in place of Pd for complete oxidation of methane.

Show Abstract ▼

Abstract: The increasing availability of low-cost and low pressure, renewable H2 from wind and solar means has triggered tremendous interest in developing low pressure ammonia synthesis with N2 as energy carrier as well as green fertilizer. As such Cs-promoted Ru/MgO catalysts used in Kellogg process show superiority to Fe-based catalysts at milder conditions, however, as known, the surface poisoning of Ru sites by competitive strong H2 dissociative adsorption limits the overall rate. It is demonstrated for the first time that the use of simple polar MgO(111) to replace non-polar MgO as support can significantly alleviate the hydrogen poisoning and facilitate an unprecedented ammonia production rate by its high intrinsic proton capture ability.